Manual #016-0159-956
13
9. Next, select the preferred units of measurement for your SmarTrax
controller. Press the Left or Right arrow to select either Feet-Decimal,
Feet-Inches, or Metric. Press the Down arrow to set the value
10. Press the Left or Right arrows to set the Wheel Base of your machine
(Refer to Chapter 5 for measurement instructions). When you are
finished, press the Down arrow to save the displayed setting.
Important: The following measurements are critical for
proper and accurate operation of your SmarTrax or
QuickTrax system. Measure carefully.
Note: If a generic machine type was selected in Step 3,
proceed with the following instructions to program the
Wheel Base and Minimum Turning Radius for your
vehicle.
If a tune set was available for your specific machine and
selected in Step 3, proceed to Step 12.
To Next Page
Loading...
