CHAPTER 5
76 SmarTrax™ Calibration & Operation Manual
• SP Sprayer FBoom - Self-propelled sprayer with a front boom
• Rear Steered - Rear-steered machine
2. Select OK.
3. Select Next. The following screen will appear
FIGURE 6. Steering Control Device Selection Screen
NOTE: The Control Device field will display a (-) until a valid control device is selected.
4. SmarTrax Node Control Systems Only - Select the steering control device:
• Raven Hydraulic - SmarTrax hydraulic valve is controlling the vehicle steering.
• Steer Ready - An optional steering control system was installed at the factory.
5. Select OK.
6. Refer to the appropriate System Disengage Calibration section on the following pages for the machine’s
specific system configuration.
CALIBRATE THE SMARTRAX SYSTEM
NOTE: The calibration wizard will be displayed the first time the SmarTrax module is accessed after
installation or any time the Reset SmarTrax option is selected.
1. Park the machine on a level surface.
2. Locate and select the SmarTrax module. The calibration wizard will start automatically if the SmarTrax system
requires calibration.
To Next Page
Loading...
