Chapter 6
114 Viper Pro Installation & Operation Manual
Touch the icon to toggle the turn around lock feature on to provide guidance back along the last swath and
ignore the headlands area. Touch the icon again to toggle the turn around lock feature off to allow guidance
along the headlands area.
Note: If an optional SmarTrax or SmartSteer system is installed with the Viper Pro, a reverse
sense icon may display in the map area during operation. Refer to the SmarTrax or
SmartSteer Operation Manual for more information about operating the SmarTrax or
SmartSteer system on the Viper Pro field computer.
Setting the Pivot Pattern
If Swath Guidance is enabled, the Viper Pro will automatically display the ‘Guide’ tab when a job is opened. To
begin swath guidance with the pivot pattern:
1. Start with the machine located at a point on the outside of the center pivot area and touch the ‘Set A’ button
on the screen.
2. Drive along the outside of the pivot pattern area and touch the ‘Set B’ button on the screen. Viper will create
a circular guidance path using the ‘A’ and ‘B’ points selected and display guidance paths toward the inside
of the circle.
Note: Currently, this pattern does not require that a complete pivot pass be driven to create a guidance
path, however, best results are usually obtained by driving further along the initial pivot swath
before setting the ‘B’ point.
To Next Page
Loading...
