Chapter 9
182 Viper Pro Installation & Operation Manual
How to Create a Spray/No-Spray Map
1. Start a new job.
2. Touch the Scout tab.
3. Select Record, then Zone. The Record Field Feature screen displays.
4. Select Spray or No-Spray.
Note: Only one zone type may be created at a time.
5. Enter the offset distance in feet [meters] from the center of the implement or boom.
6. Select the direction (left or right) to offset the zone boundary while driving the perimeter of the field feature.
Note: To record the boundary at the center of the swath width or implement, enter an offset of zero and
select either left or right.
7. Touch OK. Viper draws the boundary line on the Scout map as the machine travels along the zone
boundary.
8. To close the boundary, touch Finish.
Note: Spray/no-spray zones do not have the auto close feature. Touch the Finish button and select the
Zone to finish at the end of the boundary.
9. To define additional spray/no-spray zones, repeat step 3 through 8 for each spray or no-spray boundary.
Once a zone is created, it can be viewed on the Scout tab and on the AccuBoom tab. The AccuBoom tab
will show all finished zones as well as allow the operator to create the finished AccuBoom spray/no-spray
map when all zones have been defined.
Note: Any area not defined will default to a spray zone. However, if the create boundary selection has
been checked, it is important to create the outer boundary of the field as a spray zone.
If an existing field boundary has been selected for use in an AccuBoom enabled job, the selected
boundary will be displayed in the Map area. The operator may still define additional zones if
necessary for the job.
To Next Page
Loading...
