Raven Viper Pro - Boom or Section Cal

Chapter 4
46 Viper Pro Installation & Operation Manual
Pr SGain (Pressure System Gain)
The default setting for the Sgain value is 100. To adjust the system aggressiveness, enter a value between 1
and 999 as necessary.
Note: It is recommended to increase or decrease the current value in increments of 10 or less when
making adjustments to the Sgain setting. If the new value does not produce significant or notable
changes in the system response, increments of 20 may be used.
Increase the Sgain value if the observed product pressure increases too slowly or if the system takes a long
time to reach a set standby pressure or rate input change. If the system is consistently over shooting a set
standby pressure or oscillating around a target rate, decrease the Sgain value until the system stabilizes.
Boom or Section Cal
The boom setup process detailed in this section is required to configure the field computer to the application
equipment or implement. This procedure sets the overall width used for guidance of the machine as well as
boom or implement section widths used for control of product application.
1. From the main screen, touch Menu, then Setup and Boom to display the Boom Setup screen.
2. Touch the Overall Width field and use the on-screen keypad to enter the machine or implement swath
width. The overall width is the machine width used for Guidance control without fence row nozzles or foam
markers. This value must be entered using the units displayed at the bottom of the Boom Setup screen.
3. Touch the Number of Boom Sections value and enter the corresponding number of the highest boom
sense connector used by the application system.
Note: The total number of booms may include “skipped” sections or boom sense wires not connected in
some cases. Raven boom sense wires are color coded as follows:
Section
Number
Lead Wire
Color
Section
Number
Lead Wire
Color
1. Black 9. White/Blue
2. Brown 10. Pink
3. Blue 11. Yellow/White
4. Black/White 12. Green/White
5. Brown/White 13. Red/White
6. Blue/White 14. White/Yellow
7. White/Black 15. White/Green
8. White/Brown 16. White/Red