Chapter 8
138 Viper Pro Installation & Operation Manual
Product Control Settings Area
The Product Control Settings area displays an overview of the following calibration settings and values used by
the control system to monitor or adjust the rate of product application:
The following data displays are shown in the Product Control Settings area for reference and monitoring
purposes only:
Area/Hour. Displays the current area per hour covered during product application. This value is calculated
using the programmed section set up and the vehicle speed.
Vol/Min. Displays the current volume per minute monitored by the selected product node or control channel
during active application. This value is calculated using the flow of product monitored by the flow meter.
PWM. Displays the current duty cycle of the PWM valve controlling product application (if applicable).
To modify product control settings, touch within the product control settings area on the CAN Controller Status
screen.
Note: Before changing any of the product control settings, be sure to select the correct product node or
control channel by touching the corresponding radio button displayed at the top of the feature
settings area.
• Tank Volume • Spreader (Constant) • Standby Pressure
• Area/Hour (Display only) • Valve Cal • Pre Set PW
• Vol/Min (Display only) • Valve Cal 2 • PW Freq
• Rate Cal • Valve Advance • Ratio Rate
• Rate Bump (+/-) • Fan/Pump Cal • Valve Delay
• Meter Cal/Density • Min PW • PWM (Display only)
• Max PW
To Next Page
Loading...
