8
Manual No. 016-0171-122 Rev. I 139
Advanced Settings and Features
Node Control Settings Screen (Page 1)
Touch within the Product Control Settings area to view the first screen of settings for the selected product node
or control channel.
Note: Touch the Next button to access additional product control settings for the selected product node
or control channel.
Tank Volume. Enter the initial volume of product in a tank or bin. As product is applied using the
corresponding node or control channel, the Viper Pro will calculate the volume remaining in the tank or bin and
display the value on the CAN Controller Status screen, the Tally Registers screen and in the Display Data
prompt.
A tank volume is required when using the low tank alarm value. Refer to the Low Tank section on page 135 for
more information on the low tank alarm.
When refilling a tank or bin during an application, the tank volume may be quickly reset using the Tally
Registers screen. Refer to the Tally Registers section on page 98 for information on resetting the tank volumes
to a preset value.
Rate Cal. The rate cal value is the target rate to which the system will adjust while applying the corresponding
product. Review the Rate Cal(s) section on page 42 for more information about the rate cal setting.
Note: Refer to Appendix B, Calculating the Calibration Values, to verify the flow rate limits for the flow
meter and spray nozzles installed on the sprayer. Contact a local Raven or sprayer supply dealer
for additional information or assistance.
Rate Bump (+/-). The rate bump feature allows the equipment operator to quickly adjust the rate of product
application during a job. Enter the value by which the target rate will be increased or decreased when the rate
bump buttons are selected on the Application Control prompt.
See the Application Rates Area section on page 87 for more information about the Application Rates Area on
the main screen and using the rate bump feature during a field application.
To Next Page
Loading...
