Raven Viper Pro - Autoboom Status Indicator; Wireless Communication Status

Chapter 8
146 Viper Pro Installation & Operation Manual
AutoBoom™ Status Indicator
The status of an optional Glide Series AutoBoom system is displayed at the bottom of the main screen.
The AutoBoom status is only displayed if a Glide Series AutoBoom system has been installed and on the
Raven CANbus system.
For complete calibration and operation procedure, refer to the AutoBoom Calibration & Operation Manual.
Wireless Communication Status
The status of wireless communications is displayed along the right side of the main screen below the map
area.
Note: For more information on using the wireless communication features with the Viper Pro, see
Appendix J, Wireless Communications and Remote Service.
For instructions on installing and setting up the Slingshot Field Hub, refer to the Field Hub
Installation Guide provided with the wireless device.
Wireless
Communication
Status Icon