Chapter 8
130 Viper Pro Installation & Operation Manual
Section Assignments
Some equipment configurations require the Viper Pro to either control hardware in reference to specific
product nodes or control channels or apply or not apply products in reference to a specific boom or implement
section.
For Example:
Granular or dry application equipment may be configured to supply product to the left and right booms from
separate bins.
A liquid chemical is not supplied to fence row nozzle sections.
To configure the Viper Pro for these equipment configurations, the Boom Select feature must be used. To
access the Boom Select screen:
1. Touch within the Product Control area on the main screen and then touch the Boom Cals area on the
CAN Controller Status screen.
The Boom Select screen for sections 1 through 5 will display.
2. Assign products to boom sections as appropriate for the application equipment or system configuration. The
system plumbing or configuration must be capable of the assignments shown on the Boom Select screen.
3. Touch Next to view the Boom Select screen for sections 6 through 10 (if applicable).
4. Once the section assignments are configured properly for each section, touch the OK button to accept the
displayed settings and return to the CAN Controller Status screen. Touch the Cancel button to exit the
Boom Select screen without saving changes to the section assignments.
To Next Page
Loading...
