9
Manual No. 016-0171-122 Rev. I 179
Using AccuBoom™
AccuBoom™ Spray/No-Spray Mapping
AccuBoom can be set up to operate based on a variety of different map features that define spray and no-
spray zones. The AccuBoom Setup screen allows the operator to select the desired method of operation for
AccuBoom.
The following methods are available for setting up or creating an AccuBoom map:
• Standard AccuBoom
• Create AccuBoom No-Spray Map
• Load AccuBoom No-Spray Map
• Create Map from Field Boundary
Standard AccuBoom™ Method
The standard method automatically controls sections based upon previously applied or covered areas of a job.
An Rx map may be used to further control the AccuBoom operation in this mode. If an Rx map is used, the
extents of the Rx map define the field boundaries while zero rate zones define areas where AccuBoom
automatically turns the booms off.
Note: Be sure that the ‘Enable Zero Rate Shut-Off’ is selected. If zero rate zones are used in multiple Rx
maps, they must coincide and be the same in all maps used in the job.
To Next Page
Loading...
