Chapter 8
134 Viper Pro Installation & Operation Manual
Feature Settings Area
The information displayed in the Feature Settings area is an overview of the following settings for the selected
product control node.
To modify the feature or alarm settings for the above features, touch within the feature settings area on the
CAN Controller Status screen.
Note: Before changing any of the feature or alarm settings, be sure to select the correct product node or
control channel by touching the corresponding radio button displayed at the top of the feature
settings area.
Node Feature Settings Screen (Page 1)
Touch within the Feature Settings area to view the first screen of settings for the selected product node or
control channel.
Note: Touch the Next button to access additional alarm and feature settings for the selected product
node or control channel.
• Dual Flow %/FER Cal • Vacuum/Bin Alarm • Low PSI Alarm
• Off Rate % • Decimal Shift • Max PSI Alarm
• Low Tank • Zero Speed Shutoff • Standby Pressure Enable
• Low Limit • Display Smoothing • Dual Loop Control
• Flow/Shaft Alarm • Agitator • Smart Control
• Ratio Rate •
To Next Page
Loading...
