3
Manual No. 016-0171-122 Rev. I 21
Installation, Start Up and Registration
DGPS Receiver Connection
Signal from a DGPS receiver must be routed into the Viper Pro via the serial connector labeled ‘GPS Receiver/
DGPS’ on the main interface or chassis interface cable. For information on configuring the Viper Pro to receive
signal from the connected DGPS Receiver, refer to the Serial Communication Port Setup section on page 163.
Note: The ‘Internal GPS Receiver Output’ connector on the chassis interface cable is not used with the
Viper Pro field computer.
FIGURE 5. DGPS Receiver Connection Example Viper Pro with
Phoenix 200 (Integrated Receiver/Antenna)
NOTICE
Carefully read and follow all installation
instructions included with the DGPS receiver
and antenna and any optional DGPS
components before connecting the Viper Pro
field computer or related cabling.
To Next Page
Loading...
