Chapter 7
124 Viper Pro Installation & Operation Manual
Using Product Chaining
Note: If starting an AgX job using the product chaining feature, a multiproduct VRA key will be required.
Chained products will be displayed in the Application Rates area and by the radio buttons at the top of the
Viper Pro main screen.
The product chain is denoted by the letter ‘C’ in the above areas. The superscript type indicates the active
product node or control channel in the chain. The letter ‘C’ will change color if the ‘Enable Auto Advance’ option
has been selected. If so, the ‘C’ will be black. If not, the ‘C’ will be red.
Note: The “Application Rates” heading will be hidden if multiple product nodes or control channels are
enabled to allow all information to be displayed on the main screen.
When controlling more than five products over a CANbus network, touch the drop down arrow in
the upper, right of the screen to switch the map display to other available control channels or the
product chain profile.
To Next Page
Loading...
