CHAPTER
3
Manual No. 016-0171-122 Rev. I 13
C hapter 3
Installation, Start Up
and Registration
Overview of the Installation Process
The following sections are intended as an overview of the Viper Pro installation process. These instructions
cover basic installation of the Viper Pro field computer and supplied components and cabling.
Note: For instructions on installing additional hardware with the Viper Pro, refer to instructions provided
with the additional or optional component(s). Refer to the Raven CANbus Network Installation
Manual for additional information on building a CAN (Controller Area Network) system.
Basic installation of the Viper Pro system is as follows:
1. Review kit contents
2. Mounting the Viper Pro field computer
3. Mounting the DGPS receiver and antenna
4. Route and connect interface cable(s) or chassis cables
5. Connect any optional CAN or GPS components
To Next Page
Loading...
