Appendix B
226 Viper Pro Installation & Operation Manual
Using the Calibration Assistance
1. Make sure any section switches are turned OFF before powering the field computer on.
2. Touch within the Product Control area on the main screen.
3. Touch within the Miscellaneous Settings area on the CAN Controller Status screen. The Miscellaneous
Settings screen will display.
4. Touch the Calibration Assistance button on the Miscellaneous Settings screen. The Speed Calibration
screen will appear.
5. Mark off the physical distance to be driven for the test.
6. Enter a measured test distance, in feet [meters], in the Test Distance box.
Note: A distance of at least 500 feet [152 meters] should be used for this test. A shorter distance may
give less accurate results.
7. Touch Next.
8. Begin driving the machine toward the test distance starting point at normal speed. When the beginning of
the test distance is reached, touch the Begin Cal Run button. **Calibrating** will begin flashing on-screen.
To Next Page
Loading...
