Raven Viper Pro - Starting a Job with External Rate Control; Registration Tab

Appendix H
270 Viper Pro Installation & Operation Manual
3. Set the Auxiliary Comm Port settings to:
• Baud = 9600
• Data Bits = 8
• Parity = None
• Stop Bits = 2
4. Select the Serial Rate radio button.
5. Touch OK to return to the main Viper screen.
Connecting the GreenSeeker® RT200 to the Viper Pro
1. Connect the GreenSeeker® Interface Module to PDA Cable to the GreenSeeker® RT200.
2. Connect the DB-9 connector on the GreenSeeker® Interface Module to the Auxiliary Comm Port connector
on the Viper harness.
Starting a Job with External Rate Control
Note:
External Serial Rate control is only available for Product #1. Make sure the system is configured to
apply the desired product from the first product.
1. Select Menu, then Start Job.
2. Select New Job.
3. Using the screen keyboard, enter a name for the job in the Job Name field. If no name is entered, the date
and time are used for the job name.
4. Select the desired options from the list.
5. Touch Next. If AccuBoom has been selected from the options list, select AccuBoom option desired and
touch Next.
6. If Swath Guidance has been selected from the option list, select the desired Swath Guidance pattern and
touch Next.
7. In the Product Selection screen, enter the number of products for the current application.
8. Touch Next. The Product #1 Setup screen displays.
9. Using the screen keyboard, enter a product name in the Product Name field.
10. For External Serial Rate Control, select Serial Rate.
Note: The Serial Rate selection will only appear if the Auxiliary Comm Port has been configured for
Serial Rate. If the Serial Rate selection does not appear in the Product #1 setup screen, go back
and set up the Auxiliary Comm Port for Serial Rate.
11. Touch OK.