3
Manual No. 016-0171-122 Rev. I 25
Installation, Start Up and Registration
4. If the Viper Pro is set as the CAN Controller, the Viper Pro will attempt to establish communication with the
CANbus system. The CAN Initialization Results screen displays the results of CANbus detection.
5. If the status of the CAN nodes is displayed properly, touch the Start Viper button to finish the start up
sequence.
Note: Refer to Detecting CANbus Nodes section on page 33, for more information on the CAN
Initialization Results screen, or information on setting up or troubleshooting the CANbus or CAN
nodes.
If the field computer is enabled to receive web notifications via the Slingshot server, a prompt or
dialogue may be displayed after the Start Viper button is selected and the Main screen is
displayed. Refer to the Wireless File Transfer section on page 193 for more information.
6. The Viper Pro main screen will display. For a description of the features and information displayed on the
main screen, see Start Up section on page 23.
To Next Page
Loading...
