Chapter 5
68 Viper Pro Installation & Operation Manual
AccuBoom™ Control
The AccuBoom control feature allows the Viper Pro to automatically turn the boom sections on or off in
reference to a coverage or as-applied map. As the boom enters an area where product has previously been
applied, AccuBoom will control boom sections off. When the boom section returns to area not yet covered, the
AccuBoom feature will turn the sections back on.
Note: AccuBoom turns booms off when the vehicle location goes outside an Rx Map. AccuBoom will
also turn boom sections off when entering zero rate zones on an Rx map if Enable Zero Rate
Shut-off has been enabled in the AccuBoom setup.
See Chapter 9, Using AccuBoom™, for more information on using the AccuBoom feature with the Viper Pro
field computer.
Product Chaining
The product chaining feature allows the field computer to link product tanks or bins together in series while
applying product to a field. When one tank or bin runs out, Viper automatically switches to another tank or bin
and keeps applying product reducing trips to a nurse tank or tender truck to refill products.
Be sure the field computer is set up or equipped as follows:
• The products being chained must have their valve type setup as either “Fast Close” or “PWM Close” before
enabling product chaining.
• The Vac/Bin Alarm and Low Tank Alarm must be set up and turned on before beginning product chaining if
either of these options is selected as an Auto Advance method.
• The tank volume should be set up before starting a job. If advance on low tank alarm is selected and the
tank volume is zero, bin chaining will immediately advance product control to the next tank.
• If Advance on Bin Level Sensor Alarm is to be used, all products in the chain must be equipped with a bin
level sensor.
Refer to the Starting a New AgX Job section on page 69 or Starting a Standard Job section on page 77 for
information on enabling the product chaining feature when setting up a job. See Chapter 7, Product Chaining,
for details on using the product chaining feature during a job.
To Next Page
Loading...
