5
Manual No. 016-0171-122 Rev. I 73
Using the Viper Pro System
4. Touch the product channels in the order which the tanks or bins should be activated when the previous
channel is empty.
Note: Touch the Reset button to clear any channel selections and restart the selection process.
5. Select the Enable Auto Advance option to allow the Viper Pro to automatically advance to the next product
in the chain. If the auto advance feature is disabled, the Viper Pro will display a prompt to allow the operator
to manually advance to the next tank or bin.
6. Select the advance setting which will trigger the Viper Pro to warn the operator or automatically advance to
the next channel. Select only one advance setting to avoid setup errors.
Note: If Advance or Warn on Bin Level Sensor Alarm is selected, all products in the chain must have
a bin level sensor enabled.
7. When creating an new chain profile, the Viper Pro will automatically create a profile name based upon the
selected channels and settings. To modify the chain profile name, or enter a custom profile name, touch the
Change button at the bottom of the Create Chain Profile screen and use the on-screen keyboard to rename
the profile.
8. When all settings for the chain profile are set, touch the OK button displayed in the lower, right corner of the
screen to accept the profile settings and return to the Assign Recommendations to Channel screen.
Note: If a product chain profile has been selected, the chained product channels will be highlighted on
the Assign Recommendations to Channel screen.
Select a recommendation for the chain as described below to complete the chain setup process.
To Next Page
Loading...
