5
Manual No. 016-0171-122 Rev. I 79
Using the Viper Pro System
8. Press Next. If Product Application was selected, the Product Selection screen displays.
CAN nodes are controlled in a sequential manner and each single product node provides one product
control channel. The operator may only enable the number of control channels currently available on the
machine when setting up a new job. It is recommended to select the maximum number of product control
channels available on the machine each time a new job is started to allow the most flexibility during product
application.
For Example:
If product will be applied from a single tank, but the tank contains a mixture of three products, the
operator must enable one control channel to control rate for the mixture.
To only apply products associated with control nodes 4 and 5, the operator must select 5 on the
Product Selection screen during job setup. If only product nodes 1 and 2 in a 5 product CANbus
system will be used during a job, it is still recommended to select 5 products to allow the operator
to enable or disable remaining product nodes during the job as necessary without beginning a new
job. This also allows the job to be re-opened at a later date to apply additional products using other
product nodes.
9. Enter the number of products which will be applied during the job application.
10. Enter the number of product chains to be used during the field operation.
To Next Page
Loading...
