Raymarine E-Series - Page 115

– Cultural features.
Note: A dotted or dashed collision alarm zone indicates that
there is insufcient cartographic information for the collision alarm
to function correctly. In these situations, the collision alarm will
NOT function.
Setting up the anti-collision alarm zone
1. Press the MENU button.
2. Select Alarm Setup.
3. Select Navigation Alarms Setup.
4. Select Setup Alarm Zone .
If you are using the chart application when you access this menu
item, a visual indication of the alarm zone is displayed in front
of the vessel icon.
5. To specify the range in front of your vessel that will be monitored,
press the ADJUST RANGE softkey and use the rotary control to
adjust the value.
6. To specify the bearing from your vessel (width of the zone),
press the ADJUST ANGLE softkey and use the rotary control to
adjust the value.
7. Press the OK button to save the changes, or the CANCEL
button to revert to the previously saved settings.
Radar alarms setup
Menu item Description Options
Guard Zones
Sensitivity
The guard zone feature
in the radar application
triggers an alarm when
a target is within a
specied zone. You can
adjust the sensitivity of
the alarm. Ensure that
the sensitivity is not set
too low, or targets may
be missed and the alarm
will not be triggered.
0 to 100%
Fishnder alarms setup
This section describes the settings you can change using the
shnder alarms setup menu.
Menu Item Description Options
Fish Alarm Alarm which responds
to quantities of shnder
targets
OFF, ON
Fish Alarm Sensitivity If the Fish Alarm is
set to ON, an alarm is
triggered when the sh
return strength reaches
the sensitivity that you
specify.
1 to 10
Using alarms and MOB functions
115