Raymarine E-Series - System Setup Menu

21.4 System setup menu
The following table describes the various options in the System Setup menu for your multifunction display.
Menu item Description Options
Boat Details
The accurate operation of the collision alarm is dependent on
you supplying suitable values for the Boat Details setting. You
should specify the minimum safe depth, beam, and height for
your vessel. The values you specify MUST be appropriate for
safe navigation, and must also take into account the position of
the GPS antenna on your vessel, as the collision alarm uses
data from the GPS antenna.
• Minimum Safe Depth
• Minimum Safe Beam
• Minimum Safe Height
Position Mode
Determines how positioning data is displayed — as Latitude /
Longitude coordinates, or Loran TDs.
• Lat / Long (default)
• TDs
TD Setup When the Position Mode (see above) is set to TDs, you can
specify the chain identier, slave, and ASF values.
Chain
• Various options, depending on cartography.
Slave 1/2
• Various options, depending on cartography.
ASF 1/2
• –09.9 to +09.9
Simulator
Enables or disables simulator mode, which allows you to practice
operating your multifunction display without data from a GPS
antenna, shnder (DSM sonar), or any other external unit.
• OFF (default)
• ON
• DEMO
Simulator Speed Enables you to specify the speed at which the vessel icon will
move when the Simulator mode is enabled (see above).
• 1x
• 2x
• 3x
Customizing your display
245