Raymarine E-Series - Fishfinder Presets and Display Modes

12.3 Fishnder presets
The shnder provides you with four preset congurations available
on the shnder toolbar. These enable you to quickly select
appropriate settings tailored for various situations.
Each preset has been congured to provide the best operating
parameters for the shnder. However, it is possible to manually
adjust the presets if necessary. The four presets are:
• Single — this preset provides quick access to a single-frequency
conguration, suitable for general shing conditions.
• Dual — this preset provides a dual frequency conguration.
You can either display two different frequencies at the same
time in one window, or display one frequency at full-screen on
your master display and the other frequency at full-screen on an
additional networked display.
• Shallow — this preset optimizes the shnder display for shallow
waters.
• Deep — this preset optimizes the shnder display for deep
waters.
Display modes
When using presets, you can either select the relevant preset and
start using the default conguration immediately, or you can adjust
the preset to your needs using the display modes:
• Zoom
• Bottom Lock
• A-Scope
Any changes you make to a preset are retained when you switch
off the power to your multifunction display.
Selecting a shnder preset
From the shnder main screen:
1. Press the appropriate softkey to select from:
• PRESET 1 SINGLE,
• PRESET 2 DUAL,
• PRESET 3 SHALLOW or
• PRESET 4 DEEP
After a few moments, the shnder display will change to the new
mode. This is indicated in the top left-hand corner of the status bar.
Using the shnder
173