10.4 Enabling AIS
Enabling AIS in the chart application
In the 2D chart view:
1. Select the 2D CHART LAYERS softkey.
2. Use the AIS TARGETS softkey to select the ON option.
Enabling AIS in the radar application
In the radar application:
1. Select the PRESENTATION softkey.
2. Use the AIS LAYER softkey to select the ON option.
10.5 Displaying AIS vectors
You must have the correct data available before AIS vectors can
be displayed.
A target is dened as active when it has the following data displayed
graphically:
• A COG/SOG vector indicating the predicted distance that a target
will travel within a given period of time.
• A heading and direction of turn indicator.
Enabling and disabling AIS vectors
In the chart or radar application:
1. Move the cursor over the relevant AIS target.
2. Press the AIS VECTOR softkey until the ON or OFF option is
selected, as appropriate.
3. Press the OK button.
Note: The same target vector and safe zone settings apply to
both radar MARPA and AIS targets.
Using AIS
153
To Next Page
Loading...
