mountain several miles inland from the coastline. Although the
coastline may be much nearer, it may not appear on the radar
until the vessel is closer to shore.
• Some targets, such as buoys and small boats, can be difcult
to discern, because they do not present a consistent reecting
surface as they bob and toss about in the waves. Consequently
these echoes tend to fade and brighten, and at times disappear
momentarily.
• Buoys and small boats often resemble each other, but boats can
often be distinguished by their motion.
Note: A GPS receiver and a fast heading sensor are required
for MARPA operation, and to maximize radar/chart overlay
performance.
Assigning a scanner to a radar display
If your system has 2 radar scanners you can select which one to
use for the current radar view.
In the radar application:
1. Press the MENU button.
2. Select Radar Setup.
3. Select the Select Scanner menu item.
A list of connected scanners is displayed.
4. Select the scanner you want to use with the current radar
application.
Naming a radar scanner
You can name radar scanners for easy identication.
In the radar application:
1. Press the MENU button.
2. Select Radar Setup.
3. Highlight the Select Scanner menu item.
4. Select the EDIT NAME softkey.
The on-screen keyboard is displayed.
5. Use the on-screen keyboard to enter a name for the scanner,
then select SAVE.
124
E-Series Widescreen User reference
To Next Page
Loading...
