• To use an existing waypoint select the USE THIS WAYPOINT
softkey.
• For a new waypoint select the PLACE WAYPOINT softkey.
5. Repeat Steps 3 to 4 for each subsequent waypoint, until the
route is complete.
6. To follow the route immediately without saving it for future use
(Quick Route), select the FOLLOW (QUICK) ROUTE softkey.
7. To save the route for future use, press the SAVE ROUTE softkey.
Note: If you place a waypoint at the wrong position, press the
UNDO WAYPOINT softkey.
Building a route using the waypoint list
In the chart application:
1. Select the PLANNING softkey.
2. Select the BUILD NEW ROUTE softkey.
3. Select the USE WAYPOINT LIST softkey.
4. Highlight the waypoint you want to use from the waypoint list.
5. Select the INSERT WAYPOINT softkey.
6. Repeat Steps 4 to 5 for each existing waypoint you want to add
to the route, until the route is complete.
7. To follow the route immediately without saving it for future use
(Quick Route), select the FOLLOW (QUICK) ROUTE softkey.
8. To save the route for future use, select the SAVE ROUTE softkey.
Build a route from a track
You can create a route from a recorded track.
When a track is converted the system creates the closest route
through the recorded track, using the minimum number of
waypoints. Each waypoint created will be saved with the depth and
temperature data (if applicable) for that position.
Note: If a track break occurs, only the last segment is converted
to a route.
Building a route from a track
In the chart application:
1. Select the PLANNING softkey.
2. Select the MY TRACKS softkey.
The Track List is displayed.
3. Select the CREATE ROUTE FROM TRACK softkey.
4. Highlight the required track in the list.
5. Select the CREATE ROUTE FROM TRACK softkey.
6. Select the YES softkey to name the route, or NO to accept the
default route name.
On completion, the maximum deviation of the route from the
recorded track is displayed and the new route is added to the route
list. It can now be displayed, edited and erased etc. in the same
way as other routes in the system.
Building a route from a track displayed on the chart
In the chart application:
1. Position the cursor over the required track.
62 E-Series Widescreen User reference
To Next Page
Loading...
