10A-165
ENGINE AND CYLINDER BLOCK ASSEMBLY
Flywheel: Removal - Refitting
F9Q
10A
REFITTING
I - REFITTING PREPARATION OPERATION
a Use SURFACE CLEANER (see Vehicle: Parts
and ingredients for the repairwork) (04B, Consu-
mables - Products) to clean and degrease:
-the flywheel pressure face on the crankshaft,
-the flywheel threading on the crankshaft.
a parts always to be replaced: Flywheel bolts (10,
03,03,14).
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the flywheel.
a Screw in the new flywheel bolts without tightening
them.
a Position the (Mot. 1677).
a Torque and angle tighten the flywheel bolts (30
N.m + 62˚).
III - FINAL OPERATION
a Refit:
-the « pressure plate - disc » assembly (see Me-
chanism / Disk: Removal - Refitting) (21A, Ma-
nual gearbox),
-the manual gearbox (see Manual gearbox: Remo-
val - Refitting) (20A, Clutch),
-the left-hand suspended engine mounting (see
19D, Engine mounting, Left-hand suspended
engine mounting: Removal - Refitting, page
19D-1) ,
-the front axle subframe (see Front axle sub-fra-
me: Removal - Refitting) (31A, Front axle compo-
nents),
-the radiator mounting cross member (see Radiator
support cross member: Removal - Refitting)
(41A, Front lower structure).
-the front left-hand wheel driveshaft (see Front left-
hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts),
-the front right-hand wheel driveshaft (see Front ri-
ght-hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts),
-the starter (see 16A, Starting - Charging, Starter:
Removal - Refitting, page 16A-16) ,
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
- the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the battery (see Battery : Removal - Refitting)
(80A, Battery),
a Fill the manual gearbox (see Manual gearbox oil:
Draining - Refilling) (21A, Manual gearbox).
a Refit:
- the engine undertray,
- the engine cover.
To Next Page
Loading...
