Renault F4R - Exhaust Gas Temperature Sensor: Removal - Refitting

19B-50
EXHAUST
Exhaust gas temperature sensor: Removal - Refitting
F9Q, and 870
19B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine cover,
-the engine undertray bolts,
-the engine undertray,
-the windscreen wiper arms (see Rear screen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the battery (see Battery: Removal - Refitting)
(80A, Battery),
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the intercooler air inlet pipe (see 12B, Turbochar-
ging, Intercooler air inlet pipe: Removal - Refit-
ting, page 12B-41) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the exhaust gas temperature sensor
connector (1) .
a Unclip the wiring (2) of the exhaust gas temperature
sensor.
Essential special tooling
Mot. 1807 Spanner for tightening
exhaust gas temperature sen-
sor
Tightening torquesm
the exhaust gas tempe-
rature sensor
40 N.m
137668
137669