Renault F4R - Particle Filter Temperature Sensors: Removal - Refitting

19B-53
EXHAUST
Particle filter temperature sensors: Removal - Refitting
F9Q, and 870
19B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery : Removal -
Refitting) (80A, Battery).
a Remove:
-the engine undertray bolts,
-the engine undertray.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the particle filter temperature sensor
connector (1) .
a Unclip the particle filter temperature sensor wiring
(2) .
a Remove the particle filter temperature sensor (3) .
REFITTING
I - REFITTING PREPARATION OPERATION
a Coat the threading of the particle filter temperature
sensor with COPPER-ALUMINIUM LUBRICANT
(see Vehicle: Parts and ingredients for the repai-
rwork) (04B, Consumables - Products).
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the particle filter temperature sensor.
a Clip on the particle filter temperature sensor wiring.
a Connect the particle filter temperature sensor con-
nector.
III - FINAL OPERATION
a Refit the engine undertray.
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
138087
137208