Renault F4R - Injector Holder Shim: Removal - Refitting

12A-31
FUEL MIXTURE
Injector holder shim: Removal - Refitting
K4M
12A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
-the engine cover,
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
-the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) .
a Remove:
- the dipstick,
- the bolts (1) from the dipstick tube,
- the dipstick guide.
a Remove:
-the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-17) ,
- the inlet manifold (see 12A, Fuel mixture, Inlet
manifold: Removal - Refitting, page 12A-23) ,
- the « injector rail - injector » assembly (see 17B,
Petrol injection, Injector rail - Injectors: Remo-
val - Refitting, page 17B-19) .
Tightening torquesm
bolts 1 and 2 on the
injector holder shim
30 N.m
bolts 3, 4, 5, 6, 7, 8, 9
and 10 on the injector
holder shim
25 N.m
upper timing cover bolt 46 N.m
right-hand pendulum
suspension bolt
62 Nm
dipstick guide tube bolts 10 N.m
K4M, and 858 or 866
136574