Renault F4R - Page 925

19B-51
EXHAUST
Exhaust gas temperature sensor: Removal - Refitting
F9Q, and 870
19B
a Remove the exhaust gas temperature sensor (3)
using the tool (Mot. 1807).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the exhaust gas temperature sensor.
a Torque tighten the exhaust gas temperature sen-
sor (40 N.m).
a Clip on the exhaust gas temperature sensor wiring.
a Connect the exhaust gas temperature sensor con-
nector.
II - FINAL OPERATION
a Refit:
-the intercooler air inlet pipe (see 12B, Turbochar-
ging, Intercooler air inlet pipe: Removal - Refit-
ting, page 12B-41) ,
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the battery (see Battery: Removal - Refitting)
(80A, Battery),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
- the windscreen wiper arms (see Rear screen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
- the engine undertray,
- the engine cover.
137667