Renault F4R - Page 334

11A-160
TOP AND FRONT OF ENGINE
Cylinder head: Removal - Refitting
F4R
11A
-the turbocharger (see 12B, Turbocharging, Tur-
bocharger: Removal - Refitting, page 12B-8) ,
-the catalytic converter (see 19B, Exhaust, Cataly-
tic converter: Removal - Refitting, page 19B-17)
,
-a new right-hand differential output seal (see Diffe-
rential output seal: Removal - Refitting) (21A,
Manual gearbox),
-the front right-hand wheel driveshaft (see Front ri-
ght-hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts).
a Fill the manual gearbox (see Manual gearbox oil:
Draining - Refilling) (21A, Manual gearbox),
a Refit:
-the lower engine tie-bar (see 19D, Engine moun-
ting, Lower engine tie-bar: Removal - Refitting,
page 19D-33) ,
-the timing belt (see 11A, Top and front of engine,
Timing belt: Removal - Refitting, page 11A-29) ,
-the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-18) ,
-the crankshaft accessories pulley (see 11A, Top
and front of engine, Crankshaft accessories
pulley: Removal - Refitting, page 11A-15) ,
-the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) ,
-the air conditioning pipe bolt on the inlet manifold.
a Fit the engine wiring.
a Refit:
-the spark plugs (see 17A, Ignition, Spark plugs:
Removal - Refitting, page 17A-5) ,
-the ignition coils (see 17A, Ignition, Coils Remo-
val - Refitting, page 17A-1) ,
-the camshaft dephaser solenoid valve (see 11A,
Top and front of engine, Camshaft dephaser
solenoid valve: Removal - Refitting, page 11A-
184) ,
-the camshaft position sensor (see 17B, Petrol in-
jection, Camshaft position sensor: Removal -
Refitting, page 17B-13) .
a Fit the intercooler air outlet pipe.
a Refit:
-the bolts of the intercooler air outlet pipe on the
throttle valve,
- the bolt of the intercooler air outlet pipe on the inlet
manifold,
- the dipstick guide.
a Connect:
- the fuel supply pipe to the injector rail,
- brake servo vacuum pipe ,
- the brake servo vacuum pipe connector,
a Refit:
- the fuel vapour rebreathing pipe,
- the oil vapour rebreathing pipe.
a Connect:
- the air pressure sensor connector to the inlet mani-
fold,
- the oil vapour rebreathing solenoid valve connec-
tor,
- the injector connectors,
- the air pressure sensor connector to the intercooler
air outlet pipe.
- the air temperature sensor connector to the inter-
cooler air outlet pipe,
-the coolant temperature sensor connector to the
water chamber,
- the heater matrix hose,
- the cooling hose to the water chamber.
a Using the (Mot. 1448), fit:
- the heater matrix hose clip,
- the clip of the water chamber outlet hose.
a Refit:
- the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
- the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
- the radiator mounting cross member (see Radiator
support cross member: Removal - Refitting)
(31A, Front axle components),
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),