13B-34
DIESEL INJECTION
High pressure pump: Removal - Refitting
K9K, and 832
13B
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
-the engine undertray,
-the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) ,
-the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres).
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Refit the engine cover.
a Reprime the fuel circuit using the manual priming
pump.
a Check that there are no diesel leaks.
a Apply the after repair procedure using the diagnos-
tic tool :
-connect the diagnostic tool,
-select "Injection computer",
-go to repair mode,
-display the "After repair procedure" for the selected
computer,
-select "High pressure pump" in the "List of compo-
nents stored by this computer" section,
-carry out the operations described in the "After re-
pair procedure" section.
To Next Page
Loading...
