Renault F4R - Page 561

13B-49
DIESEL INJECTION
High pressure pump: Removal - Refitting
K9K, and 834
13B
a Refit:
-a new seal on the intermediate air pipe between
the turbocharger and the intercooler,
-the intermediate air pipe clip between the turbo-
charger and the intercooler.
a Clip the intermediate air pipe between the turbochar-
ger and the intercooler on the intercooler air inlet pi-
pe.
a Refit:
-the high pressure pipe between the high pressure
pump and the injector rail (see 13B, Diesel injec-
tion, High-pressure pipe between the rail and
injector: Removal - Refitting, page 13B-87) ,
-the timing belt (see 11A, Top and front of engine,
Timing belt: Removal - Refitting, page 11A-29) ,
-the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-18) ,
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment).
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing).
-the lower engine tie-bar (see 19D, Engine moun-
ting, Lower engine tie-bar: Removal - Refitting,
page 19D-33)
-the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) ,
-the engine undertray,
-the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
-the engine cover.
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Apply the after repair procedure using the diagnos-
tic tool :
-connect the diagnostic tool,
-select "Injection computer",
-go to repair mode,
- display the "After repair procedure" for the selected
computer,
- select "High pressure pump" in the "List of compo-
nents stored by this computer" section,
-carry out the operations described in the "After re-
pair procedure" section.