13B-114
DIESEL INJECTION
Injector rail: Removal - Refitting
K9K, and 830
13B
-the high pressure pipe between the high pressure
pump and the injector rail (see 13B, Diesel injec-
tion, High-pressure pipe between the pump and
rail: Removal - Refitting, page 13B-71) ,
-the turbocharger air outlet pipe (see 12B, Turbo-
charging, Intercooler air inlet pipe: Removal -
Refitting, page 12B-41) ,
-the engine cover.
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Check the high pressure circuit (see High pressure
pipe: Checking) .
a Apply the after repair procedure using the diagnos-
tic tool :
-connect the diagnostic tool,
-select "Injection computer",
-go to repair mode,
-display the "After repair procedure" for the selected
computer,
-select "Injector rail pressure sensor" in the section
"List of components controlled by this computer",
-carry out the operations described in the "After re-
pair procedure" section.
To Next Page
Loading...
