14A-6
ANTIPOLLUTION
Exhaust gas recirculation solenoid valve: Removal - Refitting
F9Q
14A
III - FINAL OPERATION
a Refit:
-the exhaust gas recirculation assembly (see 14A,
Antipollution, Exhaust gas recirculation as-
sembly: Removal - Refitting, page 14A-18) ,
-the exhaust gas recirculation rigid pipes (see 14A,
Antipollution, Exhaust gas recirculation rigid
pipe: Removal - Refitting, page 14A-30) ,
-the intercooler air inlet pipe (see 12B, Turbochar-
ging, Intercooler air inlet pipe: Removal - Refit-
ting, page 12B-41) ,
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the battery (see Battery : Removal - Refitting)
(80A, Battery),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
-the engine undertray,
-the engine cover.
a Apply the after repair procedure using the diagnostic
tool:
-connect the diagnostic tool,
-select « Injection computer » ,
-go to repair mode,
-display the « before/after repair procedure » for the
computer selected,
-select « Exhaust gas recirculation solenoid valve »
in the « List of components controlled by this
computer » section,
-carry out the operations described in the « After re-
pair procedure » section.
To Next Page
Loading...
