17B-8
PETROL INJECTION
Petrol injection computer: Removal - Refitting
F4R or K4M
17B
a Disconnect the connector (2) from the petrol injec-
tion computer.
a Remove:
-the « Petrol injection computer - computer
support » assembly,
-the nuts (3) of the petrol injection computer from
the support,
-the petrol injection computer.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the petrol injection computer on the support.
a Connect the petrol injection computer connectors.
a Fit the « Petrol injection computer - computer
support » assembly.
a Refit:
- the petrol injection computer on the battery tray,
- the petrol injection computer cover.
II - FINAL OPERATION
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Apply the after repair procedure using the diagnos-
tic tool :
- connect the diagnostic tool,
- select « petrol injection computer » ,
- go to repair mode,
-display the « after repair procedure » for the selec-
ted computer,
- carry out the operations described in the « after re-
pair procedure » section.
136463
134213