19A-46
COOLING
Water pump: Removal - Refitting
F4R
19A
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
a Remove:
-the coolant pump bolts (1) ,
-the coolant pump,
-the coolant pump seal.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Coolant pump seal
(10,06,01,21).
a Clean the joint faces with SUPER CLEANING
AGENT FOR JOINT FACES (see Vehicle: Parts
and ingredients for the repairwork) (04B, Consu-
mables - Products).
II - REFITTING OPERATION FOR PARTS
CONCERNED
a Refit a new gasket to the coolant pump.
a Coat the coolant pump bolts with FRENETANCHE
(see Vehicle: Parts and ingredients for the repai-
rwork) (04B, Consumables - Products).
a Refit:
- the coolant pump,
- the coolant pump bolts.
136494
Note:
The coolant pump bolts are not the same length,
mark their position.
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
WARNING
To ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
To Next Page
Loading...
