Research Instruments INTEGRA 3 - Fitting Tubing to a SOS

Syringes

Research Instruments Ltd
9
Secon 9

Use hard polythene tubing as supplied by RI. Use of so tubing will
result in poor specimen control.
1. Slide the nut over the tubing.
 The non-threaded end should be pushed over rst.
2. Push the end of the tubing rmly onto the p of the ng.
3. Tighten the nut onto the ng. Use only nger pressure.
4. Fit the other end of the tubing to the Micropipee Holder.
Figure 9-5
Figure 9-6
Figure 9-7
Figure 9-8