Integra 3™ Safety Warnings
Research Instruments Ltd
3
Secon 3
disassemble or modify any part of the Integra 3, or
substute any component for any other. Doing so may result
in damage to specimens, and this voids the warranty and/or
service contract.
operate unless properly mounted to a microscope.
use the power cable and power supply adaptor supplied
with the system.
The cable to the power supply is the Disconnect Device for
this equipment. To remove all electrical power from this
product, disconnect the power cable from the electrical outlet.
Equipment should be posioned so as to allow easy access to
the power cable. The appliance coupler or mains plug is used as
the disconnect and must remain readily operable.
To avoid the risk of electric shock, this equipment must
only be connected to a mains supply with protecve earth.
Not to be used in a paent environment.
The microscope itself must be maintained to a high standard.
Problems such as worn focus mechanisms or an insecure video
camera may lead to unreliable focus and image stability, and
could lead to embryo damage.
Do not modify this equipment without
authorisaon of the manufacturer.
To Next Page
Loading...