Rexroth IndraDrive C Electrical Data 6-29
DOK-INDRV*-HCS02.1****-PR02-EN-P
CAUTION
Damage to the drive controller
⇒
Strain relief for the motor power cable must be
provided within the control cabinet, or you can use
the optionally available connection accessory
HAS02.1.
Note: Observe the following for use within the scope of C-UL:
• Use 60/75°C copper wire only
• Use Class 1 wire only or equivalent
• Suitable for use on a circuit capable of delivering not more
than 8 kA (10 kA) rms symmetrical amperes for a
maximum voltage of 500 V (400 V)
To Next Page
Loading...
