Ricoh 150 - Messages Related to Wireless Connection

8. Troubleshooting
122
8
Messages Related to Wireless Connection
150BW model
Message
Causes
Solutions
Failed to connect.
Try again.
Wireless connection to
the device failed.
• Check that there are no
devices in the surroundings
that generate radio waves
that could interrupt wireless
communication, and then try
the wireless connection
again.
• Reboot this machine and the
device, and then retry the
wireless connection.
**** (source device
name) was
disconnected.
The connection to the
device has been
disconnected.
• Check that there are no
devices in the surroundings
that generate radio waves
that could interrupt wireless
communication, and then try
the wireless connection
again.
• Check whether the device is
executing a high-load
process.
Cannot rename device
while connecting.
Disconnect and set up
again.
During the wireless
connection, you touched
the "Device name" entry
field on the
Dev.Info/Setting screen.
Change the device name of this
machine after disconnecting the
wireless connection with the
device.
page 97 "Dev.Info/Setting"
Enter a device name
using 4 to 30
characters.
A 0–3 character device
name was attempted to
be set when changing
the device name of this
machine.
The device name for this
machine must be at least four
characters long.
page 97 "Dev.Info/Setting"