Bit Switches
D432/D433 78 SM
3-4
Printing the sample image on
reports
Bit 4: 0, Bit 3: 0
= The upper half only
Bit 4: 0, Bit 3: 1
= 50% reduction in sub-scan
only
Bit 4: 1, Bit 3: 0
= Same size
Bit 4: 1, Bit 3: 1
= Not used
“Same size” means the sample image is printed at
100%, even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set
to “0” to enable this switch.
Refer to Detailed Section Descriptions for more on
this feature.
5-6
Not used
Do not change the settings.
7
Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the
pages are reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected
paper size when page separation has taken place.
Other pages are printed without reduction.
Printer Switch 0F [SP No. 1-103-016]
No FUNCTION COMMENTS
0-1
Smoothing feature
Bit 1: 0 Bit 0: 0 = Disabled
Bit 1: 0 Bit 0: 1 = Disabled
Bit 1: 1 Bit 0: 0 = Enabled
Bit 1: 1 Bit 0: 1 = Not used
(0, 0) (0, 1): Disable smoothing if the machine
receives halftone images from other
manufacturers fax machines frequently.
2
Duplex printing
0: Disabled
1: Enabled
1: The machine always prints received fax
messages in duplex printing mode:
3
Binding direction for Duplex
printing
0: Left binding
1: Top binding
0: Sets the binding for the left edge of the stack.
1: Sets the binding for the top of the stack.
To Next Page
Loading...
Need help?
General
