SERVICE PROGRAM MODE TABLES
SM 5-67 B264/B265
Service
Tables
SMTP Certification Encryption 5860 6
This setting determines whether the password for SMTP certification is encrypted.
0: Automatic
1: No encryption done
2: Encryption done
POP Before SMTP 5860 7
This setting determines whether the transmission connects with the POP server first
for certification before it connects to the SMTP server for sending.
0: No connection to POP server
1: Connection to POP server
Standby Wait Time After POP3 Certification 5860 8
This SP sets the amount of time to allow for the connection to the SMTP server after
the transmission has connected to the POP server and been certified during the
execution of POP Before SMTP.
[0~10000/300/1]
RX Protocol 5860 9
This SP specifies POP3 protocol or switches off receiving.
0: No receiving
1: POP3 protocol
POP3/IMAP4 Server Name 5860 10
This SP specifies the POP3/IMAP4 server that uses POP Before SMTP during mail
receiving. The server can be specified either by IP address or host name. If you use
the host name, you also need the name of the DNS server.
POP3/IMAP4 User Name 5860 11
This SP sets the user name used during POP3/IMAP4 certification.
POP3/IMAP4 Password 5860 12
This SP sets the password used during POP3/IMAP4 certification.
POP3/IMAP4 Certification Encryption 5860 13
This SP specifies whether password encryption is done for POP3/IMAP4 certification.
0: Automatic
1: No encryption done
2: Encryption done
POP3 Server Port Number 5860 14
This SP sets the number of the POP3 server port.
[1~65535/110/1]
IMAP4 Server Port Number 5860 15
This SP sets the number of the IMAP4 server port.
[1~65535/143/1]
SMTP RX Port Number 5860 16
This SP sets the number of the port that receives SMTP mail.
[1~65535/25/1]
Mail RX Interval 5860 17
This SP sets the timing for mail received at regular intervals.
[2~1440/15/1 min.]
Note: Setting this SP to "0" switches off receiving mail at timed intervals.
To Next Page
Loading...
