ORIGINAL TRANSPORT AND EXIT
B714 22 SM
4.5.2 DOUBLE-SIDED ORIGINALS
Shortly after the transport motor has been
turned on, the inverter solenoid is
activated and junction gate [A] opens. The
original is then scanned and transported
towards the reverse table [B].
Shortly after the original exit sensor [C]
detects the trailing edge of the original, the
inverter solenoid turns off and the junction
gate [D] closes.
Next, the inverter motor turns on and the
inverter roller [E] starts rotating to feed the
original from the reverse table.
Then the original is fed to the transport roller
and the scanning area [F] (where the
reverse side is scanned).
After scanning the reverse side of the original,
the original is then sent to the reverse table
[G] a second time and turned over. This
ensures that the double-sided original will be
properly stacked in the correct order, front
side down, in the original exit tray [H].
B597D105.WMF
B597D107.WMF
B597D106.WMF
B597D108.WMF
[E]
[A]
[B]
[F]
[G]
[H]
[C]
[D]
To Next Page
Loading...
