FAX OPTION INSTALLATION PROCEDURE
B779 2 SM
1.2 FAX OPTION INSTALLATION PROCEDURE
CAUTION
Before installation:
1. If there is a printer option in the machine, print out all data in the printer
buffer.
2. Push the operation switch to put the machine in standby mode. Make
sure the power LED is off, turn the main switch off, and then disconnect
the power cord and the network cable.
NOTE: This installation procedure uses the following symbols.
: Screws : Connectors
1. After removing the accessories from the box, read the serial number on the box
and write it on the serial number tape provided.
2. Attach the serial number tape near the serial number plate of the mainframe.
3. Remove the controller unit [A] ( x 2)
4. Remove the cover [B] ( x 2)
B779I102.WMF
[A]
[B]
To Next Page
Loading...
