Ricoh B264 - Original Feed-In Mechanism; Pick-Up and Separation

ORIGINAL FEED-IN MECHANISM
SM 19 B714
Auto Reverse
Document
Feeder B714
4.4 ORIGINAL FEED-IN MECHANISM
4.4.1 PICK-UP AND SEPARATION
When the original is put on the original table, it contacts the original stopper [A] and
pushes the actuator [B] out of the original set sensor [C].
When Start  is pressed, the pick-up motor [D] turns on and the original stopper
cam [E] rotates. The original stopper lowers and releases the original.
Next, the pick-up roller cam [F] lowers the pick-up roller, and then the feed motor
[G (at this location but not shown in the drawing)] turns on to feed the top sheet of
paper. After being fed from the pick-up roller, the top sheet is separated from the
stack by the separation roller [H] and the feed belt [I].
B597D109.WMF
B597D505.WMF
[H]
[I]
[A]
[B]
[C]
[D]
[E]
[F]
[G]