ADJUSTMENT
SM 41 B546
Booklet
Finisher
B546
3.2.3 STAPLING POSITION
After replacing the finisher board, do this adjustment. Doing this adjustment once
will affect all paper sizes and all stapling positions.
1. Remove the upper rear cover.
2. Turn on dip switches 3 -1 and -2 on the finisher board.
3. Press the following switch on the finisher board.
Using A4: Switch 1 (SW1)
Using 81/2" x 11": Switch 2 (SW2)
• After pressing the switch, the upper exit unit will open and the transport belt
will rotate.
4. Within five seconds after pressing the switch, place one sheet of A4/8
1/2" x 11"
paper between the jogger fences and push it until it touches the shutter.
When the staple tray paper sensor detects the paper, the stapler will staple
(rear, 1 point).
5. Take out the stapled paper manually and check the staple position.
Staple position: Good → Turn off dip switches 3 -1 and -2 to end the
procedure.
Staple position: No good → Change the staple position by doing the
following steps.
6. Adjust the staple position by pressing switch 1 or 2.
Switch 1: Move the front (0.3 mm/press)
Switch 2: Move to the rear (0.3 mm/press)
7. Press switches 1 and 2 simultaneously to store the adjustment data. After
pressing the switches, check the staple position again.
8. Turn off dip switches 3 -1 and -2, then turn off the copier main switch.
Rear Front
SW2
SW1
Staple
290 ± 2 mm (A4Y), 273 ± 2 mm (LTR)
B546R555.WMF
1
Dip Switch 3
23 56784
ON
B546R554.WMF
To Next Page
Loading...
