Ricoh B264 - Merging Applications

MERGING APPLICATIONS ON ONE SD CARD
SM 5 B783
Printer/
Scanner
Option B783
1.3.2 MERGING APPLICATIONS
Do this procedure to put more than one
application on one SD card.
This procedure shows you how to move
the DOS application to the PS3 SD card.
1. Turn off the copier.
2. Remove the SD card slot cover [A] (
x1).
3. Put the Source (DOS) SD card [B] in
C3. This card contains the application
that you want to copy.
NOTE: The PS SD card cannot be the
source card, because it cannot
be copied.
4. Put the Target (PS3) SD card in C1
[C]. The application on the card in C3
will be copied to this card.
5. Open the front door.
6. Turn the copier on.
7. Go into the SP mode and select SP5873 001.
8. Touch "Execute".
9. Read the instructions on the display and touch "Execute" to start copying.
10. When the display tells you copying is completed, touch "Exit".
11. Turn the copier off.
12. Remove the Source SD card from C3. Remove the target SD card from C1 and
insert it in C2 [D].
13. Turn the copier on.
14. Go into the User Tools mode and check that all the applications on the SD card
in C2 are enabled:
User Tools> System Settings> Administrator Tools> Firmware Version> Next
15. Turn the copier off again, then:
• Attach the SD card slot cover.
• Tape the copied source card (DOS) to the faceplate of the controller box.
• Attach the rear cover of the machine.
B783I901.WMF
[A]
[B]
[C]
[D]