Ricoh B264 - G4 Internal Switches; G4 Parameter Switches; Ip Fax Switches

BIT SWITCHES
SM 79 B779
Fax Option
B779
3.2.7 G4 INTERNAL SWITCHES
The G4 internal switches (SW00 to 1F) are displayed but do not change these
settings.
3.2.8 G4 PARAMETER SWITCHES
The G4 parameter switches (SW00 to 0F) are displayed but do not change these
settings.
3.2.9 IP FAX SWITCHES
IP Fax Switch 00 SP No. 1-111-001
No. FUNCTION COMMENTS
0 Not used Do not change this setting.
1
IP Fax Transport
0: TCP, 1: UDP
Selects TCP or UDP protocol for IP-Fax
2
IP Fax single port selection
0: OFF, 1: ON (enable)
Selects single data port.
3
IP Fax double ports (single data
port) selection
0: OFF, 1: ON (enable)
Selects whether IP-Fax uses a double port.
4
IP Fax Gatekeeper
0: OFF, 1: ON (enable)
Enables/disables the gatekeeper for IP-Fax.
5
IP Fax T30 bit signal reverse
0: LSB first, 1: MSB first
Reverses the T30 bit signal.
6
IP Fax max bit rate setting
0: Not affected, 1: Affected
When "0" is selected, the max bit rate does
not affect the value of the DIS/DCS.
When "1" is selected, the max bit rate affects
the value of the DIS/DCS.
7
IP Fax received telephone number
confirmation
0: No confirmation, 1: Confirmation
When "0" is selected, fax data is received
without checking the telephone number.
When "1" is selected, fax data is received only
when confirming that the telephone number
from the sender matches the registered
telephone number in this machine. If this
confirmation fails, the line is disconnected.